Plinius Hautonga integruotas stiprintuvas
Aukštos klasės, didelio galingumo integruotas garso stiprintuvas.
Itin universalus ir tinkatis prie daugelio kolonėlių, šis stiprintuvas sukuria skaidrų ir gyvą bei labai dinamišką garsą.
Turime ekspozicijoje
The versatile Hautonga is a perfectly equipped and well balanced piece that derives from preceding development in earlier Plinius integrated amplifiers. The aesthetic is the distinctive Plinius rounded front and it is available in silver or black linished anodised finish.
The rear panel has five line level RCA inputs with Phono RCA and a balanced XLR pair additional as standard. There is a Pre Out for those that only want to use the pre-amp stage and the Line Out connection for archiving or other ancillary equipment. Trigger in and out connectors provide for multi-room or home theatre simplicity.
A full function remote lets you scroll through inputs from your seat. HT Bypass, standby mode for true low power operation that keeps the circuit active to deliver peak performance with minimal delay, mute and volume controls, display brightness adjustment and the full complement of CD player functions are all available from the remote.
Careful attention has been paid to signals and circuit layout with short signal paths, optimal component placement and wiring specification working in harmony to extract exciting depth and detail from any musical recording.
Taking integrated refinement to a new level, the Hautonga is an amplifier that has set new standards for performance, ease of use and reliability.
POWER
200 watts RMS per channel into 8 ohms.280 watts RMS per channel into 4 ohms.
Both channels driven from 20Hz to 20kHz at less than 0.2% total harmonic distortion
FREQUENCY RESPONSE
20Hz to 20kHz ±0.2dB-3dB at 5Hz and -3dB at 70kHz
DISTORTION
Typically <0.05% THD at rated power0.2% THD and IM worst case prior to clipping
CURRENT OUTPUT
40A short duration peak per channelFuse protected
SLEW RATE
50V/µsHUM & NOISE
90dB below rated output 20Hz to 20kHz unweightedINPUT IMPEDENCE
47k ohms all inputsPhono adjustable to 47k ohms, 470 ohms,
100 ohms,47 ohms, 22 ohms
RATED PRE OUT LEVEL
1.5V RMS into 47k ohms or higherPRE OUT SOURCE IMPEDENCE
Typically 1.5k ohmsPRE OUT MINIMUM RECOMMENDED LOAD
47k ohmsLINE OUT LEVEL
190mV at 200 ohmsGAIN
Line inputs to speaker out: 40dBPhono Input To Pre-Out: 66dB on high gain, 60dB on low gain
POWER/CURRENT CONSUMPTION
600W0.4A (92W)
Class AB Idle 0.14A (32W) Standby
DIMENSIONS
Width: 450mm (17 3/4")
Depth: 400mm (15 3/4")
Weight: 14kg (30lb)
Charakteristikos
- 200W RMS @ 8ohm / 280W RMS @ 4ohm
- -3dB at 5Hz and -3dB at 70kH
- 14
- 12 / 45 / 40